Light Marina Trailers
In terms of calculating these are not significant, which I did a few mainly as a hobby until my interest ran out. Making a small amount is not worth it.
The furniture tube 50 x 50 x 2 mm is enough for a rowing boat and even for a slightly heavier boat. Square-shaped pipes are easier to weld than, for example, from making a product from a round pipe, which I initially made.
A rubber wheel costs about sixteen euros. Furniture pipe from one to two euros depending on the purchase quantity per kilo. The winch is available cheaply and the rubber parts cost four to five euros a piece. Preparation time as a hobby about three days. You need to buy the components, saw the pipes, weld them and paint the frame. Finally is the assembly of parts
The product is for lowering and lifting a small boat out of the water. The drawbar can be attached to the car's pull knop, allowing the trailer to be towed by car. As said, it was a hobby, and the product is not for EP-Calculation...
14.4.2015*10:20 (1056 -33)
www.karikolehmainen.com
epcalculation@gmail.com |
